Susceptibility in this context is understood to be an indication of how well the signal circuit can differentiate between the undesirable noise and required signal.
Electrical and data separation.
They are considered to be a special condition other than a normal power circuit.
Condition 2kva 2 5kva 5kva.
The electrical wiring will not be affected in any way.
Power control wiring separation if you are asking separation needed for interference not code we usually use 12 separation between lv signal cabling and line voltage cabling as a general rule.
Conduit systems to be occupied by communication conductors shall be separated from conduit systems to be used for supply systems by 75 mm 3 in of concrete 100 mm 4 in of masonry or 300 mm 12 in of well tamped earth.
Unshielded power lines or electrical equipment in proximity to grounded metal conduit pathway.
The problem is the possibility of induced noise in the signal or data cable.
All cabling should avoid any proximity to radio or television transmitters beacons and overhead transmission lines.
It follows that a data communication physical standard such as rs 232e would have a high susceptibility and a 1000 v 200 a ac cable has a low susceptibility.
The main electrical services entrance is protected with surge arresters transient voltage surge suppressor according to the applicable local national codes for equipment safety.
All data telecommunications or sensitive cabling should not be placed near 3 phase cables as these are normally used for heavy electrical inductive loads e g.
While code doesn t mandate any separation imo good practice calls for keeping electrical wiring and signal or data wiring at least several inches apart where they run parallel.
Unshielded power lines or electrical equipment in proximity to open or non metal pathways.
There are four classification levels of susceptibility for cables.
Air conditioning welding equipment and motors.
I also see this same distance in other specs and publications.
If open spaced power conductors are used a minimum separation of 50 mm is required.
Minimum separation distance from power source at 480v or less.
It states separations between supply and communication conduit systems.